Look-Up Control Window
This window enables you to set the parameters necessary for the download
of color look up tables. The current shape of the color look-up curves are
shown in the Look-Up Table Window.
Use Table : Tag this, if you want to download and use color
look-up tables (gamma correction table).
Look-Up Type : The type of modification on the current active color
look-up table.
The following look-up types are supported:
Normal : The same as no color correction.
Gamma : Gamma correction with input value.
Set the gamma correction value in
the <Look-Up Input> and use it by
clicking on <Apply>.
Freestyle : Modification of each pixel by hand.
Step : Leads to a curve with steps.
Set the number of desired steps in
the <Look-Up Input> and apply it by
clicking on <Apply>.
Look-UpInput : If this field is not ghosted it is used to receive
input data for the current Look-Up Type.
Apply : This button must be pressed, if a Look-Up Type with additional
parameter input in Look-Up Input should be applied to the
actived look-up curve.
All : Defines the look-up table for color scanning.
If <All> is active Red, Green and Blue will be processed with the
same curve.
Red : Defines the look-up table for the Red component.
Green : Defines the look-up table for the Green component.
Blue : Defines the look-up table for the Blue component.
If one of the above modes is active during a color scan, then Red,
Green and Blue will be processed with their individual curves.
Grey : Defines the look-up table for the Grey component.
Only used, if scanning mode is <Grey>.
Save : Save the color look-up tables to file.
Load : Load the color look-up tables from file.
Cancel : Throw away changes.
OK : Accept changes.
|
Do you have any suggestions or questions about ScanTek then email to
scantek@gmx.de |
|
Copyright 1996/97/98/2002 by Waldemar Zöhner V1.1