Max Frame Setting Window
This window enables you to edit the maximum size of the preview frame.
With this settings you can optimize the preview frame, if your object to scan
does not cover the whole flatbed.
Additionally it is very helpful, to avoid problems with "Illegal scanning
frame coordinate" SCSI Errors.
The scanning frame maximum size can be set in parts of 1/8 inch
Any input is adjusted to the allowed range and to multiples of 1/8 inch.
You should experiment with these values, if you get the SCSI Error requester
"Illegal scanning frame coordinate". In most cases you have to decrement
the Width value.
Width : The new maximum width of the scanning frame.
Height : The new maximum height of the scanning frame.
Cancel : Throw away changes.
OK : Accept changes.
|
Do you have any suggestions or questions about ScanTek then email to
scantek@gmx.de |
|
Copyright 1996/97/98/2002 by Waldemar Zöhner V1.1